Guide · Homeowners · 3 min read · Updated 17 November 2026
How to Soundproof a Ceiling Against Noise from Upstairs
Short answer
To soundproof a ceiling, remove or build below the existing ceiling, fill the joist void with acoustic mineral wool, fit resilient bars or independent joists so the new ceiling is isolated, then fit two layers of dense acoustic plasterboard and seal the edges. Ceiling soundproofing typically costs £1,800–£3,800 for a room and loses around 50–125 mm of height. Footstep noise is reduced but best treated from above.
Why noise comes through ceilings
In converted flats and older houses, the floor between storeys is often just timber joists with floorboards on top and a lath and plaster or plasterboard ceiling below. There is little mass and nothing to stop vibration passing straight down through the joists. Voices and television travel through as airborne noise. Footsteps, dropped objects and furniture moving are impact noise, which travels through the floor structure itself.
Hard floor finishes upstairs, such as laminate or wood laid without a proper acoustic underlay, make impact noise much worse.
Ceiling system options
There are three broad approaches, ranging from simple to most effective. The right one depends on ceiling height, the noise and budget.
| Approach | What it involves | Height lost | Performance |
|---|---|---|---|
| Resilient bars below existing ceiling | Bars fixed through to joists, new dense board | Around 50 mm | Moderate improvement |
| Remove ceiling, fill void, resilient bars | Insulation in void, isolated new ceiling | Around 25–50 mm | Good improvement |
| Independent ceiling joists | Separate joists not touching the existing ones | Around 100–125 mm or more | Best improvement |
What the work involves
Furniture is moved out of the room or covered, and floors are protected. Light fittings are disconnected. If the old ceiling is coming down, it creates a lot of dust and debris, especially lath and plaster, so the room is sealed off and waste is bagged and removed. Older ceilings can contain asbestos in textured coatings applied before 2000, so if you have an Artex-type ceiling, have it tested before it is disturbed.
With the joists exposed, acoustic mineral wool is fitted between them. Resilient bars are fixed across the joists, or an independent frame is built below. Two layers of dense acoustic plasterboard are fixed with staggered joints, edges are sealed with acoustic sealant, and the ceiling is skimmed. Recessed downlights are a weak point, so use surface mounted fittings or acoustic fire hoods if downlights are needed.
Most rooms take three to five days including plastering, plus drying time before painting.
- Test textured ceilings for asbestos before removal
- Fill the joist void with acoustic mineral wool
- Isolate the new ceiling from the joists
- Use two layers of dense board with staggered joints
- Seal the perimeter with acoustic sealant
- Avoid unprotected recessed downlights
Footsteps: what to expect
A good ceiling system reduces voices and television noise significantly. Footsteps will be reduced but are rarely eliminated by ceiling work alone, because vibration still travels from the joists into the walls and back into your room. That is the flanking problem, and it is why impact noise is best treated at the source.
If you have a good relationship with your upstairs neighbour, or you own both floors, treating the floor above with acoustic insulation and a resilient floating floor or mat is often more effective, and can cost less. Timber floor soundproofing costs £1,200–£2,800. Many flat leases already require hard floors to be laid over an acoustic underlay, so it is worth checking the lease of the flat above.
Building regulations and conversions
If you are converting a house into flats in England, Approved Document E of the Building Regulations applies to the new separating floors and walls, and pre-completion sound testing is normally required to show they meet the minimum standards. In Scotland, sound insulation between dwellings is covered by Section 5 of the Building Standards Technical Handbooks and a building warrant is generally needed.
Upgrading the ceiling in your own existing flat for comfort is usually not controlled in the same way. However, if you are altering a ceiling that forms part of the fire separation between flats, it must still provide the required fire resistance. Leaseholders should also check the lease and get freeholder consent where needed.
Losing ceiling height
Losing 50 to 125 millimetres of height is rarely noticed in a Victorian or Edwardian room with high ceilings. In modern flats with ceilings around 2.4 metres, a deeper independent system can feel low, and cornices, coving and door frames may need adjusting. Removing the old ceiling and fitting resilient bars directly to the joists is the best compromise where height is limited.
Talking to the neighbour upstairs
Before committing to ceiling work, it is worth a conversation with whoever lives above. Many footstep problems come from hard floors laid without an acoustic underlay, or furniture without felt pads, and simple changes such as rugs and runners on main walking routes can make a real difference. If they are planning new flooring, they may be willing to include a proper acoustic layer, especially if their lease requires it anyway.
If you own the flat above and let it out, you can treat the floor there directly between tenancies. Where relations are difficult, keep a simple note of when the noise happens and what it sounds like. It helps a specialist recommend the right system, and it is useful if you need to raise the matter with a managing agent or freeholder under the lease. A short, polite approach usually works better than a formal complaint as a first step, and it costs nothing.
Questions people also ask
Can you soundproof a ceiling without removing it?
Yes. Resilient bars or an independent frame can be fixed below the existing ceiling with new dense board. It gives a moderate improvement and avoids mess, but loses more height and cannot add insulation to the joist void. Removing the old ceiling usually performs better.
How much does it cost to soundproof a ceiling?
Ceiling soundproofing typically costs £1,800–£3,800 for a standard room. The lower end is a system fitted below the existing ceiling. The upper end includes removing the old ceiling, filling the void, independent joists and plastering. Room size and light fittings also affect the price.
Will a soundproofed ceiling stop footsteps?
It will reduce them, often noticeably, but rarely stop them completely. Footsteps are impact noise and travel through joists and walls as well as the ceiling. Treating the floor above with an acoustic floor or underlay, combined with a ceiling system, gives the best result.
Written and checked by the Soundproofing team. Read our editorial policy.
More guides
How Much Does Soundproofing Cost in the UK?
Soundproofing a typical UK room costs £700–£3,800. A slim resilient party wall system costs £1,200–£2,200, an independent stud party wall…
Airborne vs Impact Noise: Which Soundproofing Do You Need?
Airborne noise is sound that travels through the air, such as voices, televisions, music and barking, and is reduced by adding mass, decoupling…
How to Soundproof a Party Wall: Methods Compared
To soundproof a party wall, build a new lining in front of it that is isolated from the existing wall, fill the cavity with acoustic mineral wool,…
Approved Document E and Sound Testing Explained
Approved Document E gives the sound insulation standards for walls and floors separating dwellings in England. It applies to new homes and to…
Get a free soundproofing quote
Tell us what you need and we'll come back with a clear price.
Request a quote